Post by Scale-Master on Sept 5, 2006 19:22:54 GMT -5
The boots for the wires are machined aluminum with vinyl tubing. The bottom one is fully assembled and painted, the one above is the assembled parts. The rest of the parts are above them, the one different part is the boot for the coil.
Almost finished distributor, ready for installation.
Coil assembly, mounted and wired into the system.
Other side view of mounted distributor. Still much to do in the engine compartment (and other places).
The actual ignition wire is from an old remote controlled Countach model I had in the 70's. Saving the old stuff is not the problem, finding it when you want it is... - Mark
Almost finished distributor, ready for installation.
Coil assembly, mounted and wired into the system.
Other side view of mounted distributor. Still much to do in the engine compartment (and other places).
The actual ignition wire is from an old remote controlled Countach model I had in the 70's. Saving the old stuff is not the problem, finding it when you want it is... - Mark